Fan Guard & Finger Grille (IEC 60950 / IEC 62368-1 finger probe) is specified where the duty calls for keeping fingers and objects away from rotating fan blades in electronics, appliances and equipment while passing cooling air. The sections below cover the typical end-uses by industry, the mesh, micron and material decisions for each, installation practice, and the applications this product type is not suited to.
Typical Applications for Fan Guard & Finger Grille
Where Fan Guard & Finger Grille is specified and bought:
- Electronics OEMs: guards on 40–140 mm cooling fans in power supplies and enclosures.
- Appliance makers: guards in fan heaters, dehumidifiers and air purifiers.
- Industrial control panels: filter-fan guards on cabinet ventilation.
- Telecom & outdoor cabinets: corrosion-resistant fan guards.
How to Specify Fan Guard & Finger Grille for Your Application
- Probe compliance: Hole size and standoff must pass the IEC finger probe for the product standard (e.g. IEC 62368-1).
- Fan size & screw pitch: Match the fan frame and mounting hole spacing exactly.
- Airflow: Perforated guards with high open area lose less airflow than wire guards of the same probe rating.
- Standard: Quote IEC 60950 / IEC 62368-1 finger probe and the size designation from the table on the product page, plus any value you changed in the technical drawing.
Handling & Installation Practice
- Mount the guard with the fan screws so it is earthed through the chassis when metal.
- Check the guard does not touch the blades under vibration.
Common Selection Mistakes with Fan Guard & Finger Grille
- Using a decorative grille that fails the finger-probe test.
- Choosing a mounting pitch for the wrong fan size.
Where Fan Guard & Finger Grille Is Not the Right Choice
Not a dust filter; add a filter pad or mesh if dust must be stopped.
