316L Stainless Steel demister pads (mist eliminators) combines the construction of demister pads (mist eliminators) (ASME sizing practice) with the properties of AISI 316L (1.4404): superior resistance, including chlorides, brines, food CIP and mild acids, essentially non-magnetic, service to approx. +550 °C continuous. This page summarizes the grade data, its behavior in filtration service, comparable alloys, and the specifications supplied.
Why Choose 316L Stainless Steel for Demister Pads (Mist Eliminators)
The default filtration and process-industry grade. For demister pads (mist eliminators), this matters when superior resistance, including chlorides, brines, food CIP and mild acids is the controlling requirement.
Alloy Properties
| Grade designation | AISI 316L (1.4404) |
|---|---|
| Magnetic response | Essentially non-magnetic |
| Service temperature | approx. +550 °C continuous |
| Corrosion characteristic | Superior resistance, including chlorides, brines, food CIP and mild acids |
Corrosion Behavior in Filtration Service
316/316L adds 2–3% molybdenum to the 304 composition, which sharply improves resistance to chloride pitting and mild acids. For demister pads (mist eliminators) in marine, brine, food-CIP and chemical-process service, 316L is the default filtration grade; the L (low-carbon) variant also resists sensitization where elements are welded into frames.
Comparable Alloys
Below 316L sits 304 (general purpose, lower cost). Above it: duplex 2205 (strength + chloride resistance), 904L and Hastelloy C-276 (hot chlorides, sulfuric), Monel 400 (HF, seawater), titanium (chlorides at minimum weight) for demister pads (mist eliminators).
Specifications of Demister Pads (Mist Eliminators) Available in 316L Stainless Steel
| Pad density (kg/mu00b3) | Thickness (mm) | Wire diameter (mm) | Grade | Reference standard |
|---|---|---|---|---|
| 80 | 100 | 0.28 | General purpose | ASME approx. sizing |
| 112 | 100 | 0.28 | Standard | ASME approx. sizing |
| 144 | 100-150 | 0.28 | High efficiency | ASME approx. sizing |
| 192 | 150 | 0.23 | High efficiency | ASME approx. sizing |
| 300 | 150 | 0.15 | Co-knit glass fiber | ASME approx. sizing |
Where 316L Stainless Steel Demister Pads (Mist Eliminators) Is Used
- Oil & gas production: inlet separators, gas scrubbers and glycol contactors.
- Chemical & refining: distillation, absorption and stripping columns.
- Evaporators & desalination: stopping brine and product carry-over into vapor.
- Compressed air & vacuum: oil-mist and water separators.
Ordering Demister Pads (Mist Eliminators) in 316L Stainless Steel
- Vessel & manway: Pad diameter, number of sections and the largest piece that fits the manway.
- Pad type: Standard density for general duty, high-efficiency for fine mist, open type for fouling service.
- Support grids: Top and bottom grids with tie wires so the pad cannot lift or sag.
Mistakes to Avoid with Demister Pads (Mist Eliminators)
- Undersizing the pad area so gas velocity exceeds the design K-factor.
- Using high-density pads in fouling or waxy service, where they plug.





